16 Tines Set Fits Troy-Bilt Horse Pony Tiller 1901118
16 Tines Set Fits Troy-Bilt Horse Pony Tiller 1901118
Couldn't load pickup availability
One New Aftermarket Replacement Tiller Tine Set With Hardware
Fits Troy-Bilt Horse and Pony Models
Kit Contains: (8) LH Tines, (8) RH Tines, (32) Cap Screws, (32) Cap Screws, (32) Lock Washers
Tech Info:
(Qty. 8) Left Hand - 12" Bolo Tine, 2-5/8" and 3-18" Center to Center, Three 3/8" Diameter Mounting Holes
(Qty. 8) Right Hand - 12" Bolo Tine, 2-5/8" and 3-18" Center to Center, Three 3/8" Diameter Mounting Holes
(Qty. 32) Cap Screws - 3/8"- 1, Grade: 5
(Qty. 32) Hex Nuts - 3/8"- 16, Material: Zinc
(Qty. 32) Lock Washers - Diameter: 3/8"
Replaces Part Numbers: 1901118, 1901118A
Price was fantastic. Fit up not so much. Hole spacing was perfect for my troy bilt pony tiller but tine material was a little too deep where it crosses over tiller shaft. The eight inside tines require a shallow trough be ground in them to fit over the shaft. For me with an angle grinder and a vise that was no problem but without the proper tools, this would have been a show stopper. If it wasn't for this I would have given them a 10 instead of a 5 based upon their being a great value.
Received in record time. Tines were needing to be ground down a bit in order to fit tiller. I had a side are grinder so was able to adapt. For the price, I can't complain. Would purchase again.
They seem to be good quality steel. I installed them on a troy built horse 1 tiller. Had to file just a little to get them to fit right yet remain tight on the hub. I would buy another set of these if and when these wear out.
16 Tiller Tines Set W/Hard for Troy-Bilt Horse Pony10802 1901118 1270-1A 1270-2A